Content on this page requires a newer version of Adobe Flash Player.

Get Adobe Flash player

Metering Pump Settings Calculator

Calculate the Flow Rates for Your CDS-John Blue Metering Pumps

It's now more simple than ever to calculate your piston pump and squeeze tube pump application flow rates and other parameters with the CDS-John Blue Pump Flow Rate Calculator. Enter your information and let the Calculator do the work for you. Print it out and have it for future reference. The Calculator now features calculations in both standard and metric units.

If this is your first time using the calculator, please review the instructions below
Online Instructions

Flow Rate Pump Calculator
Select Your Pump Type


Select Your Data Preference
Select Your Drive System
Enter Your Swath Width
(row spacing distance multiplied
by the number of rows)
Inches
Enter the Number of Teeth for Your Drive & Driven Sprockets
Drive 
 
 
 
  		 Driven
  (required)
  (optional)
  (optional)
  (optional) 		To decrease pump setting, increase drive or decrease driven number of teeth

To increase pump setting, decrease drive or increase driven number of teeth
Enter Your Ground Speed Miles Per Hour

 
Terms of Use:
WARNING: All calculations are based upon the information you provided. Always verify your application rate before entering the field as variables within your system can cause differences between calculated rates and actual output rates.

Click the button below to access your pump settings.

Your Results: Estimated Pump Setting and Application Parameters

Pump Selected
Sprocket Ratio
Pump RPM RPM
 

Online Instructions:

  1. Complete all necessary input form fields. Select either "Piston Pump" or "Squeeze Tube Pump". From the pull-down menu, select your CDS-John Blue Pump Model. Select whether you work in "English" or "Metric" units of measurement. If prompted, enter your "Application Rate". Select whether your system utilizes a "Ground Drive" or a "Press/Rub Wheel". Enter your "Loaded Radius". If prompted, enter your "Swath Width". If prompted, enter your "Row Space". Enter the number of teeth for your "Drive and Driven Sprockets" (use multiple rows if necessary). Enter your "Ground Speed".

  2. Read the "Warning" and the "Terms of Use" provided.

  3. Acknowledge that you have read the "Warning" and indicate your acceptance of the "Terms of Use" by putting a check in the checkbox.

  4. Click the gray button that says, "Click Here To Get Your Pump Settings".

  5. Scroll down to the bottom of the page to view your CDS-John Blue pump settings.

  6. NOTICE: If after viewing your calculated pump settings, you decide to change any of the input form fields, be sure to resubmit your changes by clicking the gray "Click Here To Get Your Pump Settings" button once again. Failing to do so will result in improper pump settings.

 

< Previous Page